PWREP RM P8 RJ45EC FRONT RDMHUB
Rackmount DMX/RDM splitter, 8 opto-isolated RJ45 ports, configuration via screen/buttons
The PWREP RM P8 RJ45EC FRONT RDMHUB has several operating modes:
- Splitter 1 input to 8 basic outputs
- Automatic detection of the DMX input signal on any port and according to three operating modes.
- Merge of 2 DMX inputs (manual or according to priority)
- Each input can be DMX in or out (automatic or manual detection)
- Management of priorities and merge modes
- Fully configurable via the button/screen interface located on the front panel.
Download Pathscape for free : Click here.
Any further information, please contact us
- 8 Bidirectional DMX512/RDM Ports + 1 DMX512 Input + 1 DMX512 Thru
- Isolation between each DMX port: 3000V
- Automatically detects incoming DMX signals and distributes them according to the operating mode used:
- RDM Hub mode: Detects the DMX port used as input and copies the output signal to all other ports
- RDM A/B mode: Input selection via external A/B switch
- Merge mode: Merge HTP (highest takes precedence) of all ports on which an incoming DMX signal is detected. The remaining ports are used for output. DMX outputs are not RDM in this mode.
- RDM can be enabled/disabled individually per port
- RDM discovery and management from the screen/button interface
- No fuses: automatic reset of port protections following a power surge
- Configurable DMX speed and signal loss behavior
- 19-inch rack mount
- Supply voltage: 100-240Vac 50/60Hz
- Operating temperature: -10°C to 50°C
- Relative humidity: 5-95%, non-condensing
- CE certification